If you have problems with the pool filter is dirty past and do not know where to start, this article is to help diagnose the problem correctly. The filter is called de-filter can be applied to sand and cartridge.
Many people do not know where to start when trying to find the source of her dirt to pass the new filter in the pool. The first thing that needs to be done is to be inspected for the undertow. This is rarely the cause of the dirt back inBut the pool is the easiest step in the research of the problem. If there is a push-pull valves, the piston must be removed. If necessary, refer to a diagram, loosen the nut or nut and pull the tree out of the body. Check the two O-rings to pay particular attention to the upper O-ring. The upper ring causes the dirt back into the pool. If there is a problem with the lower ring of the water level, water is leaking from the drain. This will cause the pool to lose water. In reviewing the ORings look wear, scratches or cracks. If you replace the upper O-ring, to find the problem, and with a lubricant like silicone grease. If a lubricating oil will swell the rubber rings. Tip, avoiding to replace both o-rings to other problems.
If the surf is not the problem then the filter itself should be dismantled. First, examine the multiple, the unit is plastic, the grid will be set. You could be looking for broken or distorted the same manifold. Thismay be caused by excessive heat, when the distribution distorts the shape changes, and it is very easy for dirt to pass. If the collector looks OK then clean and check the network. One of the most common bear is the top spots of the grid. A tube through the center of the network and on upper edge forms a circle. Many times a small hole will be present. This may be the cause of pollution of the pool. If you do not have any holes in the top of the grid and then check theRest of the surface of the grid. Insert the replacement for holes or cracks, if found online.
Finally, as part of this project one step at a time will help to lead a successful mission. Check the backwash valve and then check the various networks. This should fix the problems with the pool filter with itself.
No comments:
Post a Comment